The accordion leak is a common and common problem, it not only affects the accordion's sound, the volume, but also the noise, so often make the player a big headache. The cause of the accordion is a variety of reasons, find the "cause" and then the right medicine.

    There are two reasons, one is made of piano box wood is not dry and good, when the climatic conditions change, the box will appear cracks and leakage. Second, in the production is not careful to leave the gap. First to determine where the gap, remove the accordion on the right side of the decorative cover and the left side of the shell driver, forced push the bellows at the same time close the face and move up and down to determine the location of the leak, and then use a thick white The gap will be blocked, to be dry after the test whether the leak can be installed to use.

    2. Bellows failure: the same way to determine what the wind around the bellows, and then remove the bellows to observe the pad of the apron is curled and there are debris, if any, clean up the flat leather pad to install the bellows. But sometimes the apron aging damage, which requires replacement replacement. The old accordion, the bellows to the light of a photo, see the bellows on the sheepskin angle is damaged air leakage, if there is a hole to be replaced sheepskin or white cloth stick together for a while.

    Accessories Loose: The fixing screws of the accordion strap and bellows strap are tightened through the housing from the inside of the housing, and loosening of these screws can cause the accordion to leak. First use the above method to determine which part of the leak, and then remove the screw, to the hole in the plug some wax can be installed. If the screws are too loose, the holes can be re-drilled with wood. The same way to solve the bellows pin loose leakage.

    Four. Reed cover: remove the accordion trim cover and the shell driver, you can see a lot of sticky sheepskin rectangular plate, which is the spring cover. It is not correct, injustice or with debris will cause leakage, adjust the spring cover must be careful, while carefully watching around, while with a straight mouth pliers a little bit of correction. Exhaust hole cover will also have the same problem, the solution is the same way. Sometimes the tension on the cover will fall off or weak, which requires re-installed or swap spring.

    5. reed box, reed: remove the bellows, you can see a lot of reed reed reed. If the spring box deformation of the leak, you can remove the reed box, in the following appropriate position mats, then reed to tighten the box. Longer use of the accordion The sound of the spring on the spring may curl, fall off, lose the wind and cause leakage, should be put on a good sound skin. In addition to each reed seat surrounded by wax sealed to prevent leakage.

    When dealing with the wind of the accordion, you should first know which places may leak, and then carefully check, accurately determine the appropriate way to deal with.